Sure, there are far more effective rounds to burn through a carbine than 9mm, just like there are far more effective self-defense cartridges for a pistol than 380 ACP. The Walther CCP M2 380 ACP is to handguns what a 9mm PCC is to carbines - which is to say it’s pure, lethal entertainment. Once it’s all cleaned and lubed, it’s time for reassembly, which requires a little more patience than it should because you need to align the gas piston as you slip the slide and frame together, but repetition is your friend. Grab the supplied brass bristled brush and go to work. As previously mentioned, this pistol is piston operated and this area does require special attention. If you’ve scrubbed and lubed a handgun before, it’s pretty much business as usual, with one exception. Should you choose to clean the pistol, now would be a good time. Now, you can depress the firing pin safety in the slide and remove the striker assembly. As soon as the extractor is free of the extractor notch, lift the rear of the slide upward as you ease the slide forward and off the frame. The spring cover should glide up the ramp of the locking block and out of the slide.īecause this is a fixed barrel pistol, the next step is a little unorthodox, though familiar to P7 owners. Next, allow the locking block to slip out the rear of the slide. Crack the manual and turn to the field-stripping section, or follow along here. The process may seem a bit complex the first few times you do it, but it becomes easier with practice. Original M1 owners will breathe a sigh of relief, while those new to the CCP may groan in despair. WHERE THINGS GET A LITTLE MORE COMPLICATEDĪ noteworthy drawback of the Walther CCP M2 is disassembly and reassembly of the pistol. An upgraded pistol will be marked with an obvious circle. Therefore, should you come across a CCP M1 on the secondary market, have a close look at the backside of the inside of the magazine well. These pistols were upgraded free of charge, and we’re told by Walther that the issue was due to a small batch of bad parts. This modification greatly reduces the likelihood of a customer going about their day believing their CCP is fully operational when it actually isn’t.Īs mentioned earlier, Walther recalled a number of CCP M1s because the pistol was capable of firing if dropped, regardless of whether the thumb safety was activated or not. We’ll go over that in detail momentarily. It’s been replaced with a simplified and far more user-friendly method, albeit still a bit unorthodox by today’s standards. The M1 required the use of an included tool for disassembly, and it was helpful to have a third hand. The first and most notable is tool-less disassembly. The new M2 variant is the recipient of several changes - we’ll call them updates - when compared to the original M1. With more rounds through the pistol, or extensive dry-fire, all the parts will probably wear in and result in a light, smooth trigger press. Again, the pull is light, but not all that smooth. It felt as though several of the trigger components were rubbing, creating excess friction. While the trigger is light, the travel on our T&E pistol was a bit on the long side and very stagy. Also in the box are a couple of extra front sights should elevation changes be necessary. The Walther CCP M2 sports polymer 3-dot sights, adjustable for windage with a flathead screwdriver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |